All satellite receivers have a built in satellite signal bar visible on your TV. However, looking at your TV while moving your satellite dish may not always be convenient. This satellite finder allows for the installer to be able to see the signal strength while moving the dish. Just hook the coax cable which leaves the dish into the finder and then a coax out of the finder into your house to the receiver. This is a great product for RVers or if you are doing a one person installation.
Frequency 950 - 2050 MHZ with in-line strength meter
Allows optimal satellite dish hook up for strongest signal
Internal gain level control
Audio tone locates satellite
No batteries required
It is designed to detect DIRECTV and DISH NETWORK satellite signals. It works great on C/Ku Band Satellite Dishes too. It is very useful for installing the satellite dish for the first time or when moving the satellite dish to another location. This meter is very simple and easy to use. Just connect the meter in between the satellite dish and the satellite receiver. You can tune and peak DIRECTV or DISH NETWORK satellite signal in a few minutes instead of wasting hours turning and tweaking the dish.
